Users Guide

show interfaces [interface] status
2. Determine the remote interface status.
EXEC mode
EXEC Privilege mode
[Use the command on the remote system that is equivalent to the above command.]
3. Access CONFIGURATION mode.
EXEC Privilege mode
config
4. Access the port.
CONFIGURATION mode
interface interface slot/port
5. Set the local port speed.
INTERFACE mode
speed {100 | 1000 | 10000 | auto}
6. Optionally, set full- or half-duplex.
INTERFACE mode
duplex {half | full}
7. Disable auto-negotiation on the port. If the speed is set to 1000, you do not need to disable auto-negotiation.
INTERFACE mode
no negotiation auto
8. Verify conguration changes.
INTERFACE mode
show config
NOTE: The show interfaces status command displays link status, but not administrative status. For link and
administrative status, use the show ip interface [interface | brief] [configuration] command.
show interface status Command Example:
Dell#show interfaces status
Port Description Status Speed Duplex Vlan
Te 0/1 Down Auto Auto --
Te 0/2 Down Auto Auto --
Te 0/3 Down Auto Auto --
Te 0/4 Down Auto Auto --
Te 0/5 Down Auto Auto --
Te 0/6 Down Auto Auto --
Te 0/7 Down Auto Auto --
Te 0/8 Down Auto Auto --
Te 0/9 Down Auto Auto --
Te 0/10 Down Auto Auto --
Te 0/11 Down Auto Auto --
Te 0/12 Down Auto Auto --
Te 0/13 Down Auto Auto --
[output omitted]
108
Interfaces