Concept Guide

* 1 Active U Te 0/33
10 Active T Po128(Te 0/41-42)
T Te 0/1
11 Active T Po128(Te 0/41-42)
T Te 0/1
12 Active T Po128(Te 0/41-42)
T Te 0/1
13 Active T Po128(Te 0/41-42)
T Te 0/1
14 Active T Po128(Te 0/41-42)
T Te 0/1
15 Active T Po128(Te 0/41-42)
T Te 0/1
20 Active U Po128(Te 0/41-42)
U Te 0/1
Dell
You can remove the inactive VLANs that have no member ports using the following command:
Dell#configure
Dell(conf)#no interface vlan <vlan-id>
->vlan-id - Inactive VLAN with no member ports
You can remove the tagged VLANs using the no vlan tagged <VLAN-RANGE> command. You can remove the untagged VLANs using
the no vlan untagged command in the physical port/port-channel.
VLT Terminology
The following are key VLT terms.
• Virtual link trunk (VLT) — The combined port channel between an attached device and the VLT peer switches.
• VLT backup link — The backup link monitors the connectivity between the VLT peer switches. The backup link sends congurable,
periodic keep alive messages between the VLT peer switches.
• VLT interconnect (VLTi) — The link used to synchronize states between the VLT peer switches. Both ends must be on 10G or 40G
interfaces.
• VLT domain — This domain includes both the VLT peer devices, VLT interconnect, and all of the port channels in the VLT connected to
the attached devices. It is also associated to the conguration mode that you must use to assign VLT global parameters.
• VLT peer device — One of a pair of devices that are connected with the special port channel known as the VLT interconnect (VLTi).
• Enhanced VLT (eVLT) — Combining two VLT domains. eVLT can operate in layer 2 and layer 3 modes. eVLT is also known as mVLT.
VLT peer switches have independent management planes. A VLT interconnect between the VLT chassis maintains synchronization of
L2/L3 control planes across the two VLT peer switches. The VLT interconnect uses 10G or 40G user ports on the chassis.
A separate backup link maintains heartbeat messages across an out-of-band (OOB) management network. The backup link ensures that
node failure conditions are correctly detected and are not confused with failures of the VLT interconnect. VLT ensures that local trac on a
chassis does not traverse the VLTi and takes the shortest path to the destination via directly attached links.
The following is a summary of VLT and its functions:
• End devices (such as switches, servers, and so on) connected to a VLT domain consider the two VLT peers as a single logical switch.
• Although VLT does not require spanning tree protocols, Dell EMC Networking recommends enabling RSTP before conguring VLT to
avoid possible loops from forming due to incorrect conguration.
• You can connect two VLT domains to create an eVLT topology.
• You can use eVLT as layer 2.
• Peer routing enables one VLT node to act as the default gateway for its VLT peer within a VLT domain.
• With peer routing, you need not use VRRP.
• You can use routing protocols in a VLT domain or between VLT domains (eVLT).
290
PMUX Mode of the IO Aggregator