Administrator Guide

-- Stack Info --
Unit UnitType Status ReqTyp CurTyp
Version Ports
---------------------------------------------------------
0 Management online I/O-Aggregator I/O-
Aggregator <<release version>> 56
1 Standby online I/O-Aggregator I/O-
Aggregator <<release version>> 56
2 Member not present
3 Member not present
4 Member not present
5 Member not present
Dell#
Configuring an NPIV Proxy Gateway
Prerequisite: Before you configure an NPIV proxy gateway on an IOA or MXL switch with the FC Flex IO
module, ensure the following:
• DCB is enabled by default.
• DCB (PFC and ETS) parameters are configured for converged traffic.
To configure the minimum number of member links that must be up for a LAG bundle to be fully up,
perform the following steps:
1. Enable Fibre Channel capability on the switch.
2. Create a DCB map.
3. Apply a DCB map on server-facing Ethernet ports.
4. Create an FCoE VLAN.
5. Create an FCoE map.
6. Apply an FCoE map on server-facing Ethernet ports.
7. Apply an FCoE Map on fabric-facing FC ports.
Enabling Fibre Channel Capability on the Switch
You must first enable an IOA and MXL switch with the FC Flex IO module that you want to configure as
an NPG for the FC protocol.
Task
Command Command Mode
Enable an IOA and MXL switch
with the FC Flex IO module for
the FC protocol.
feature fc
CONFIGURATION
242
PMUX Mode of the IO Aggregator