Administrator Guide

x - Dot1x untagged, X - Dot1x tagged
o - OpenFlow untagged, O - OpenFlow tagged
G - GVRP tagged, M - Vlan-stack, H - VSN tagged
i - Internal untagged, I - Internal tagged, v - VLT
untagged, V - VLT tagged
NUM Status Description Q Ports
* 1 Active U Po10(Te 0/4-5)
U Po11(Te 0/6)
1000 Active T Po10(Te 0/4-5)
1001 Active T Po11(Te 0/6)
Dell#
5. Show LAG member ports utilization.
Dell#show link-bundle-distribution
Link-bundle trigger threshold - 60
LAG bundle - 10 Utilization[In Percent] - 0 Alarm State - Inactive
Interface Line Protocol Utilization[In Percent]
Te 0/41 Up 0
Te 0/42 Up 0
LAG bundle - 11 Utilization[In Percent] - 0 Alarm State - Inactive
Interface Line Protocol Utilization[In Percent]
Te 0/6 Up 0
Dell#
Multiple Uplink LAGs with 40G Member Ports
By default in IOA, native 40G QSFP+ optional module ports are used in Quad (4x10G) mode, to convert
Quad mode to Native 40G mode, refer to the sample configuration. Also note, converting between Quad
mode and Native mode, and vice versa, requires that you reload the system for the configuration changes
to take effect.
The following sample commands configure multiple dynamic uplink LAGs with 40G member ports based
on LACP.
1. Convert the quad mode (4x10G) ports to native 40G mode.
Dell#configure
Dell(conf)#no stack-unit 0 port 33 portmode quad
Disabling quad mode on stack-unit 0 port 33 will make interface configs of
Te 0/33 Te 0/34 Te 0/35 Te 0/36 obsolete after a save and reload.
[confirm yes/no]:yes
Please save and reset unit 0 for the changes to take effect.
Dell(conf)#no stack-unit 0 port 37 portmode quad
Disabling quad mode on stack-unit 0 port 37 will make interface configs of
Te 0/37 Te 0/38 Te 0/39 Te 0/40 obsolete after a save and reload.
[confirm yes/no]:yes
Please save and reset unit 0 for the changes to take effect.
Dell(conf)#no stack-unit 0 port 49 portmode quad
Disabling quad mode on stack-unit 0 port 49 will make interface configs of
Te 0/49 Te 0/50 Te 0/51 Te 0/52 obsolete after a save and reload.
[confirm yes/no]:yes
Please save and reset unit 0 for the changes to take effect.
Dell(conf)#no stack-unit 0 port 53 portmode quad
Disabling quad mode on stack-unit 0 port 53 will make interface configs of
236
PMUX Mode of the IO Aggregator