Users Guide
Version Description
9.4(0.0) Supported on the FN I/O Aggregator.
8.3.17.0 Supported on the M I/O Aggregator.
Usage Information If there is a change in the conguration, the Dell Networking OS prompts you to save the new conguration.
Or you can save your running conguration with the copy running-config command.
Related Commands reset stack-unit — resets any designated stack member except the management unit.
service timestamps
Add time stamps to debug and log messages. This command adds either the uptime or the current time and date.
Syntax
service timestamps [debug | log] [datetime [localtime] [msec] [show-
timezone] | uptime]
Parameters
debug (OPTIONAL) Enter the keyword debug to add timestamps to debug messages.
log (OPTIONAL) Enter the keyword log to add timestamps to log messages with
severity from 0 to 6.
datetime (OPTIONAL) Enter the keyword datetime to have the current time and date
added to the message.
localtime (OPTIONAL) Enter the keyword localtime to include the localtime in the
timestamp.
msec (OPTIONAL) Enter the keyword msec to include milliseconds in the timestamp.
show-timezone (OPTIONAL) Enter the keyword show-timezone to include the time zone
information in the timestamp.
uptime (OPTIONAL) Enter the keyword uptime to have the timestamp based on time
elapsed since system reboot.
Defaults Not congured.
Command Modes CONFIGURATION
Supported Modes All Modes
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
9.4(0.0) Supported on the FN I/O Aggregator.
8.3.17.0 Supported on the M I/O Aggregator.
Usage Information If you do not specify parameters and enter service timestamps, it appears as service
timestamps debug uptime in the running-conguration.
To view the current options set for the service timestamps command, use the show running-
config command.
Control and Monitoring
57