Users Guide

• For a 10-Gigabit Ethernet interface, enter the keyword

TenGigabitEthernet followed by the slot/port information.

• For VLAN interface, enter the keyword vlan then a number from 1 to 4094.

Defaults The IP address on the system that is closest to the Telnet address is used in the outgoing packets.

Command Modes CONFIGURATION

Supported Modes All Modes

Command History

Version Description

9.9(0.0) Introduced on the FN IOM.

9.4(0.0) Supported on the FN I/O Aggregator.

8.3.17.0 Supported on the M I/O Aggregator.

Related Commands telnet — telnets to another device.

line

Enable and congure console and virtual terminal lines to the system. This command accesses LINE mode, where you can set the

access conditions for the designated line.

Syntax

line {console 0 | vty number [end-number]}

Parameters

console 0 Enter the keyword console 0 to congure the console port.

The console option is <0-0>.

vty number Enter the keyword vty followed by a number from 0 to 9 to congure a virtual

terminal line for Telnet sessions.

The system supports 10 Telnet sessions.

end-number

(OPTIONAL) Enter a number from 1 to 9 as the last virtual terminal line to

congure.

You can congure multiple lines at one time.

Defaults Not congured