Users Guide

upgrade system
Upgrade the bootash image or system image.
Syntax
upgrade system {flash: | ftp: | scp: | tftp: | usbflash: | stack-unit {0-5
| all} {A: | B:}
Parameters
0–5 Enter the keyword 0–5 to upgrade only the mentioned stack-unit.
all Enter the keyword all to upgrade all the member units of the stack.
ftp After entering the keyword ftp you can either follow it with the location of the
source le in this form://userid:password@hostip/filepath, or press
Enter to launch a prompt sequence.
scp After entering the keyword scp you can either follow it with the location of the
source le in this form://userid:password@hostip/filepath, or press
Enter to launch a prompt sequence.
tftp After entering the keyword tftp you can either follow it with the location of the
source le in this form://hostlocation/filepath, or press Enter to launch a
prompt sequence.
ash After entering the keyword flash you can either follow it with the location of the
source le in this form://filepath, or press Enter to launch a prompt sequence.
usbash After entering the keyword usbflash you can either follow it with the location of
the source le in this form://filepath, or press Enter to launch a prompt
sequence.
A: Enter this keyword to upgrade the bootash partition A.
B: Enter this keyword to upgrade the bootash partition B.
Defaults none
Command Modes EXEC Privilege
Supported Modes All Modes
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
9.4(0.0) Supported on the FN I/O Aggregator.
8.3.17.0 Supported on the M I/O Aggregator.
Usage Information You must reload Dell Networking OS after executing this command. Use the command upgrade system
stack-unit to copy Dell Networking OS from the management unit to one or more stack members.
Example
Dell#upgrade system ?
flash: Copy from flash file system (flash://filepath)
ftp: Copy from remote file system, IPv4 or IPv6, (ftp:/
/userid:password@hostip/filepath)
scp: Copy from remote file system, IPv4 or IPv6, (scp:/
/userid:password@hostip/filepath)
stack-unit Sync image to the stack-unit
tftp: Copy from remote file system, IPv4 or IPv6, (tftp:/
/hostip/filepath)
usbflash: Copy from usbflash file system (usbflash://
44
File Management