Users Guide

Usage Information
Restoring factory defaults deletes the existing startup conguration and all persistent settings (stacking,
fanout, and so forth).
When restoring all units in a stack, all the units in the stack are placed into stand-alone mode.
When restoring a single unit in a stack, that unit placed in stand-alone mode. No other units in the stack are
aected.
When restoring units in stand-alone mode, the units remin in stand-alone mode after the restoration. After
the restore is complete, the units power cycle immediately.
CAUTION: There is no undo for this command.
Example
Dell#restore factory-defaults stack-unit 0 clear-all
***********************************************************************
* Warning - Restoring factory defaults will delete the existing *
* startup-config and resets all persistent settings (stacking, *
* fanout, etc.) and boot environment variables (boot config, console *
* baud rate, management interface settings, etc.) *
* After restoration the unit(s) will be powercycled immediately. *
* Proceed with caution ! *
***********************************************************************
Proceed with factory settings? Confirm [yes/no]:yes
-- Restore status --
Unit Nvram Config Bootvar
-----------------------------------
0 Success Success Success
Dell#
Example (NvRAM,
all)
Dell#restore factory-defaults stack-unit all nvram
**************************************************************
* Warning - Restoring factory defaults will delete the existing *
* persistent settings (stacking, fanout, etc.) *
* All the units in the stack will be split into standalone units. *
* After restoration the unit(s) will be powercycled immediately. *
* Proceed with caution ! *
**************************************************************
Proceed with factory settings? Confirm [yes/no]:yes
-- Restore status --
Unit Nvram Config
------------------------
0 Success
1 Success
2 Success
3 Not present
4 Not present
5 Not present
Power-cycling the unit(s).
Dell#
Example (NvRAM,
single unit)
Dell#restore factory-defaults stack-unit 1 nvram
**************************************************************
* Warning - Restoring factory defaults will delete the existing *
* persistent settings (stacking, fanout, etc.) *
* After restoration the unit(s) will be powercycled immediately. *
* Proceed with caution ! *
**************************************************************
Proceed with factory settings? Confirm [yes/no]:yes
-- Restore status --
Unit Nvram Config
------------------------
36
File Management