Users Guide

• bgp — Enable BGP state change traps.
• ecfm — Enable ECFM state change traps.
• entity — Enable entity change traps.
• envmon — Enable SNMP environmental monitor traps.
• eoam — Enable EOAM state change traps
• ets — Enable ets traps
• fips — Enable FIP Snooping state change traps
• lacp — Enable LACP state change traps.
• isis — Enable ISIS adjacency change traps
• pfc — Enable pfc traps
• snmp — Enable SNMP trap
• stp — Enable 802.1d state change traps
• vlt — Enable VLT traps
• vrrp — Enable VRRP state change traps
• xstp — Enable 802.1s, 802.1w, and PVST+ state change traps
The default is all trap types are sent to host.
Defaults As above.
Command Modes CONFIGURATION
Supported Modes Programmable-Mux (PMUX)
Command History
This guide is platform-specic. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.9(0.0)
Introduced on the M I/O Aggregator.
Usage Information
In order to congure the router to send SNMP notications, enter at least one snmp-server host
command. If you enter the command with no keywords, all trap types are enabled for the host. If you do not
enter an snmp-server host command, no notications are sent.
In order to enable multiple hosts, issue a separate snmp-server host command for each host. You can
specify multiple notication types in the command for each host.
When multiple snmp-server host commands are given for the same host and type of notication (trap
or inform), each succeeding command overwrites the previous command. Only the last
snmp-server
host command will be in eect. For example, if you enter an snmp-server host inform command
for a host and then enter another snmp-server host inform command for the same host, the
second command replaces the rst command.
The snmp-server host command is used with the snmp-server enable command. Use the snmp-
server enable command to specify which SNMP notications are sent globally. For a host to receive
most notications, at least one snmp-server enable command and the snmp-server host
command for that host must be enabled.
354
Simple Network Management Protocol (SNMP) and Syslog