Users Guide

To remove the SNMP host, use the no snmp-server host ip-address [vrf vrf-name]
traps | informs [version 1 | 2c | 3] [auth | noauth | priv] [community-
string] [udp-port number] [notification-type] command.
Parameters
ip-address Enter the keyword host then the IP address of the host (congurable hosts is
limited to 16).
ipv6-address Enter the keyword host then the IPv6 address of the host in the x:x:x:x::x format.
NOTE: The :: notation species successive hexadecimal elds of zero.
vrf vrf-name Enter the keyword vrf and then the name of the VRF that the SNMP server uses
to connect to the host.
NOTE: You can use this attribute to inform the SNMP engine about the vrf
instance to be used to reach the corresponding remote host to send Trap or
Inform message. If no VRF is specied, then the default VRF is used.
traps (OPTIONAL) Enter the keyword traps to send trap notications to the specied
host. The default is traps.
informs (OPTIONAL) Enter the keyword informs to send inform notications to the
specied host. The default is traps.
version 1 | 2c | 3 (OPTIONAL) Enter the keyword version to specify the security model then the
security model version number 1, 2c, or 3:
• Version 1 is the least secure version.
• Version 3 is the most secure of the security modes.
• Version 2c allows transmission of informs and counter 64, which allows for
integers twice the width of what is normally allowed.
The default is version 1.
auth (OPTIONAL) Enter the keyword auth to specify authentication of a packet
without encryption.
noauth (OPTIONAL) Enter the keyword noauth to specify no authentication of a packet.
priv (OPTIONAL) Enter the keyword priv to specify both authentication and then
scrambling of the packet.
community-string Enter a text string (up to 20 characters long) as the name of the SNMP
community.
NOTE: For version 1 and version 2c security models, this string represents
the name of the SNMP community. The string can be set using this
command; however, Dell Networking OS recommends setting the
community string using the snmp-server community command before
executing this command. For version 3 security model, this string is the
USM user security name.
udp-port port-
number
(OPTIONAL) Enter the keywords udp-port followed by the port number of the
remote host to use. The range is from 0 to 65535. The default is 162.
notication-type (OPTIONAL) Enter one of the following keywords for the type of trap to be sent to
the host:
Simple Network Management Protocol (SNMP) and Syslog
353