Users Guide

Command Modes
• EXEC
• EXEC Privilege
Supported Modes Programmable-Mux (PMUX)
Command History
This guide is platform-specic. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.9(0.0)
Introduced on the M I/O Aggregator.
Example
Dell#show snmp user
User name: test
Engine ID: 0000178B0200000102030407
storage-type: nonvolatile active
Authentication Protocol: None
Privacy Protocol: None
User name: v1v2cwriteu
Engine ID: 0000178B0200000102030407
storage-type: nonvolatile active
Authentication Protocol: None
Privacy Protocol: None
Dell#
snmp-server community
Congure a new community string access for SNMP v3.
Syntax
snmp-server community community-name {ro | rw} [ipv6 ipv6-access-list-name
[ipv6 ipv6-access-list-name | access-list-name | security-name name] |
security-name name [ipv6 ipv6-access-list-name | access-list-name |
security-name name] | access-list-name [ipv6 ipv6-access-list-name |
access-list-name | security-name name]]]
To remove access to a community, use the no snmp-server community community-string {ro
| rw} [security-name name [access-list-name | ipv6 access-list-name |
access-list-name ipv6 access-list-name]] command.
Parameters
community-name Enter a text string (up to 20 characters long) to act as a password for SNMP.
ro Enter the keyword ro to specify read-only permission.
rw Enter the keyword rw to specify read-write permission.
ipv6 access-list-
name
(Optional) Enter the keyword ipv6 then an IPv6 ACL name (a string up to 16
characters long).
security-name
name
(Optional) Enter the keywords security-name then the security name as
dened by the community MIB.
Simple Network Management Protocol (SNMP) and Syslog
347