Users Guide

Version Description
9.3(0.0) Supported on the M I/O Aggregator.
exec-banner
Enable the display of a text string when the user enters EXEC mode.
Syntax
exec-banner
To disable the banner on terminal lines, use the no exec-banner command.
Defaults Enabled on all lines (if congured, the banner appears).
Command Modes LINE
Supported Modes All Modes
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
9.4(0.0) Supported on the FN I/O Aggregator.
9.3(0.0) Supported on the M I/O Aggregator.
Usage Information Optionally, use the banner exec command to create a text string that is displayed when you access
EXEC mode. This command toggles that display.
Related Commands
banner exec— congures a banner to display when entering EXEC mode.
line — enables and congures console and virtual terminal lines to the system.
ip radius source-interface
Specify an interface’s IP address as the source IP address for RADIUS connections.
Syntax
ip radius source-interface interface
To delete a source interface, use the no ip radius source-interface command.
Parameters
interface Enter the following keywords and slot/port or number information:
• For a 100/1000 Ethernet interface, enter the keyword GigabitEthernet
then the slot/port information.
• For a Gigabit Ethernet interface, enter the keyword GigabitEthernet then
the slot/port information.
•
For Loopback interfaces, enter the keyword loopback then a number from
zero (0) to 16838.
• For the Null interface, enter the keywords null 0.
• For a Port Channel interface, enter the keywords port-channel then a
number. The range is from 1 to 128.
• For a ten-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port information.
• For a 40-Gigabit Ethernet interface, enter the keyword fortyGigE then the
slot/port information.
Security
327