Users Guide
service-class dot1p-mapping
Congure a service-class criterion based on a dot1p value.
Syntax
service-class dot1p-mapping {dot1p0 value | dot1p1 value | dot1p2 queue |
dot1p3 value | dot1p4 value| dot1p5 value | dot1p6 value | dot1p7 value}
Parameters
value Enter a dot1p list number and value. The list number range is from 0 to 7. The range
is from 0 to 3.
Defaults For each dot1p Priority, the default CoS queue value is:
• dot1p CoS Queue
0 0-7
1 0-7
2 0-7
3 0-7
4 0-7
5 0-7
6 0-7
7 0-7
Command Modes CONFIGURATION
Supported Modes Programmable-Mux (PMUX)
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
9.4(0.0) Supported on the FN I/O Aggregator.
8.3.17.0 Supported on the M I/O Aggregator.
Usage Information To apply dot1p-queue-mapping, use the service-class dynamic dot1p command.
service-class dynamic dot1p
Honor all 802.1p markings on incoming switched trac on an interface (from INTERFACE mode) or on all interfaces (from
CONFIGURATION mode). A CONFIGURATION mode entry supersedes an INTERFACE mode entry.
Syntax
service-class dynamic dot1p
To return to the default setting, use the no service-class dynamic dot1p command.
Defaults All dot1p trac is mapped to Queue 0 unless you enable the service-class dynamic dot1p
command. The default mapping is as follows:
310
Quality of Service (QoS)