Users Guide
service-policy output — applies an output policy map to the selected interface.
qos-policy-output
Create a QoS output policy.
Syntax
qos-policy-output qos-policy-name
To remove an existing output QoS policy, use the no qos-policy-output qos-policy-name
command.
Parameters
qos-policy-name Enter your output QoS policy name in character format (32 characters maximum).
Defaults none
Command Modes CONFIGURATION
Supported Modes Programmable-Mux (PMUX)
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
9.4(0.0) Supported on the FN I/O Aggregator.
9.2(0.0) Introduced on the M I/O Aggregator.
8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
Usage Information
To specify the name of the output QoS policy, use this command. After the output policy is specied, rate-
limit, bandwidth-percentage, and WRED can be dened. This command enables Qos-Policy-Output
Conguration mode — (conf-qos-policy-out).
Related Commands
bandwidth-percentage — assigns weight to the class/queue percentage.
rate-shape
Shape the trac output on the selected interface.
Syntax
rate shape [kbps] rate [burst-KB]
Parameters
kbps Enter the keyword kbps to specify the rate limit in Kilobits per second (Kbps).
Make the following value a multiple of 64. The range is from 0 to 40000000. The
default granularity is Megabits per second (Mbps).
rate Enter the outgoing rate in multiples of 10 Mbps. The range is from 10 to 10000.
burst-KB (OPTIONAL) Enter the burst size in KB. The range is from 0 to 10000. The default
is 50.
308
Quality of Service (QoS)