Users Guide

Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
9.4(0.0) Supported on the FN I/O Aggregator.
9.2(0.0) Introduced on the M I/O Aggregator.
8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
Usage Information
Aggregate input/output QoS policy applies to all the port ingoing/outgoing trac. Aggregate input/output
QoS policy can coexist with per queue input/output QoS policies.
1. If only aggregate input QoS policy exists, input trac conditioning congurations (rate-police) apply.
Any marking congurations in aggregate input QoS policy are ignored.
2. If aggregate input QoS policy and per class input QoS policy coexist, aggregate input QoS policy
preempts per class input QoS policy on input trac conditioning (rate-police). In other words, if rate
police conguration exists in the aggregate QoS policy, the rate police congurations in per class QoS
are ignored. Marking congurations in per class input QoS policy still apply to each queue.
Related Commands
policy-map-output — creates an output policy map.
policy-map-output
Create an output policy map.
Syntax
policy-map-output policy-map-name
To remove a policy map, use the no policy-map-output policy-map-name command.
Parameters
policy-map-name Enter the name for the policy map in character format (32 characters maximum).
Defaults none
Command Modes CONFIGURATION
Supported Modes Programmable-Mux (PMUX)
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
9.4(0.0) Supported on the FN I/O Aggregator.
9.2(0.0) Introduced on the M I/O Aggregator.
8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
Usage Information To assign trac to dierent ows using QoS policy, use the Output Policy map. This command enables
Policy-Map-Output Conguration mode (conf-policy-map-out).
Related Commands
service-queue — assigns a class map and QoS policy to dierent queues.
policy-aggregate — allows an aggregate method of conguring per-port QoS using policy maps.
Quality of Service (QoS)
307