Users Guide
Usage Information
The unit of bandwidth percentage is 1%. A bandwidth percentage of 0 is allowed and disables the scheduling
of that class. If the sum of the bandwidth percentages given to all eight classes exceeds 100%, the
bandwidth percentage automatically scales down to 100%.
Related Commands qos-policy-output — creates a QoS output policy.
description
Add a description to the selected policy map or QoS policy.
Syntax
description {description}
To remove the description, use the no description {description} command.
Parameters
description Enter a description to identify the policies (80 characters maximum).
Defaults none
Command Modes CONFIGURATION (policy-map-input and policy-map-output; conf-qos-policy-in and conf-qos-policy-out;
wred)
Supported Modes Programmable-Mux (PMUX)
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
9.4(0.0) Supported on the FN I/O Aggregator.
9.2(0.0) Introduced on the M I/O Aggregator.
8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
Related Commands
policy-map-output — creates an output policy map.
qos-policy-output — creates an output QoS-policy on the router.
dot1p-priority
Assign a value to the IEEE 802.1p bits on the trac this interface receives.
Syntax
dot1p-priority priority-value
To delete the IEEE 802.1p conguration on the interface, use the no dot1p-priority command.
Parameters
priority-value Enter a value from 0 to 7.
dot1p Queue Number
0 2
1 0
Quality of Service (QoS)
305