Users Guide

Parameters
seconds Enter either zero (0) or a number as the number of seconds before MAC addresses
are relearned. To disable aging of the MAC address table, enter 0. The range is
from 10 to 1000000. The default is 1800 seconds.
Defaults 1800 seconds
Command Modes CONFIGURATION
Supported Modes
Programmable-Mux (PMUX)
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
9.4(0.0) Supported on the FN I/O Aggregator.
9.2(0.0) Introduced on the M I/O Aggregator.
mac-address-table static
Associate specic MAC or hardware addresses to an interface and virtual local area networks (VLANs).
Syntax
mac-address-table static mac-address output interface vlan vlan-id
To remove a MAC address, use the no mac-address-table static mac-address output
interface vlan vlan-id command.
Parameters
mac-address Enter the 48-bit hexadecimal address in nn:nn:nn:nn:nn:nn format.
output interface Enter the keyword output then one of the following interfaces for which trac is
forwarded:
• For a Port Channel interface, enter the keywords port-channel then a
number. The range is from 1 to 128.
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port information.
• For a 40-Gigabit Ethernet interface, enter the keyword fortyGigE then the
slot/port information.
vlan vlan-id Enter the keyword vlan then a VLAN ID number from 1 to 4094.
Defaults Not congured.
Command Modes CONFIGURATION
Supported Modes Programmable-Mux (PMUX)
Command History
Version Description
9.2(0.0) Introduced on the M I/O Aggregator.
8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
Layer 2
271