Users Guide

Te 0/5 Up 0
Te 0/13 Up 0
show port-channel-ow
Display an egress port in a given port-channel ow.
Syntax
show port-channel-flow port-channel number incoming-interface interface
{ src-mac address dest-mac address {vlan vlanid | ether-type }} [ src-ip
address dest-ip address ] [ src-port number dest-port number ]
Parameters
port-channel
number
Enter the keywords port-channel then the number of the port channel to
display ow information. The range is from 1 to 128.
incoming-interface
interface
Enter the keywords incoming-interface then the interface type and slot/
port or number information:
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port information.
src-mac address Enter the keywords src-mac then the MAC source address in the
nn:nn:nn:nn:nn:nn format.
dest-macaddress Enter the keywords dest-mac then the MAC destination address in the
nn:nn:nn:nn:nn:nn format.
vlan vlan-id Enter the keyword vlan then the VLAN ID. The range is from 1 to 4094.
ether-type Enter the keywords ether-type then the ether-value in the XX:XX format.
src-ip address Enter the keywords src-ip then the IP source address in IP address format.
dest-ip address Enter the keywords dest-ip then the IP destination address in IP address format.
src-port number Enter the keywords src-port then the source port number. The range is from 1
to 65536. The default is None.
dest-port number Enter the keywords dest-port then the destination port number. The range is
from 1 to 65536. The default is None.
Command Modes EXEC
Supported Modes All Modes
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
9.4(0.0) Supported on the FN I/O Aggregator.
8.3.17.0 Supported on the M I/O Aggregator.
Usage Information
Because this command calculates based on a Layer 2 hash algorithm, use this command to display ows for
switched Layer 2 packets, not for routed packets (use the show ip flow command to display routed
packets).
Link Aggregation Control Protocol (LACP)
267