Users Guide

ManualsBrandsDell ManualsComputer equipmentPowerEdge M IO Aggregator

251

252

253

254

255

256

257

258

259

260

Isolated Networks

This chapter describes the isolated networks commands in the Dell Networking OS.

io-aggregator isolated-network vlan

Enable the isolated-network functionality for a particular VLAN or a set of VLANs.

Syntax

[no] io-aggregator isolated-network vlan vlan-range

Parameters

isolated-

network

Specify an isolated network to be congured

vlan vlan-

range

Enter the keyword vlan followed by the member VLANs using VLAN IDs (separated

by commas), a range of VLAN IDs (separated by a hyphen), a single VLAN ID, or a

combination. For example: VLAN IDs (comma-separated): 3, 4, 6. Range (hyphen-

separated): 5-10. Combination: 3, 4, 5-10, 8.

Defaults Not congured.

Command Modes CONFIGURATION

Usage Information To add more VLANs into an isolated network, you can enter this same command at any later point. The

VLANs specied are appended to the existing set of VLANs. To remove a VLAN or a set of VLANs from an

isolated network, use the no form of command.

Supported Modes All Modes

Command History

Version Description

9.9(0.0) Introduced on the FN IOM.

9.5(0.0) Supported on the FN I/O Aggregator.

9.5(0.0) Supported on the M I/O Aggregator.

Example

Dell(conf)#io-aggregator isolated-network vlan 5-10

show io-aggregator isolated-networks

Display the VLANs that are congured to be part of an isolated network on an Aggregator.