Users Guide

Parameters
interface (OPTIONAL) Enter the following keywords and slot/port or number information:
• For the management interface, enter the keyword ManagementEthernet
then the slot/port information. The slot range is 0 and the port range is 0.
• For a 10 Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port information.
• For VLAN, enter the keyword vlan then by a number from 1 to 4094.
count value (OPTIONAL) Enter the keywords count then the count value. The ranges from 1 to
65534. The default is Innity.
Command Modes EXEC Privilege
Supported Modes All Modes
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
9.4(0.0) Supported on the FN I/O Aggregator.
8.3.17.0 Supported on the M I/O Aggregator.
Usage Information
To stop packets from ooding the user terminal when debugging is turned on, use the count option.
Example
ICMP: echo request rcvd from src 40.40.40.40
ICMP: src 40.40.40.40, dst 40.40.40.40, echo reply
ICMP: src 40.40.40.40, dst 40.40.40.40, echo reply
ICMP: echo request sent to dst 40.40.40.40
ICMP: echo request rcvd from src 40.40.40.40
ICMP: src 40.40.40.40, dst 40.40.40.40, echo reply
ICMP: src 40.40.40.40, dst 40.40.40.40, echo reply
ICMP: echo request sent to dst 40.40.40.40:
ip route
Assign a static route to the switch.
Syntax
ip route destination mask {ip-address | interface [ip-address]}[distance]
[permanent][tag tag-value]
To delete a specic static route, use the no ip route destination mask {address |
interface [ip-address]} command.
To delete all routes matching a certain route, use the no ip route destination mask command.
Parameters
destination Enter the IP address in dotted decimal format of the destination device.
mask Enter the mask in the slash prex format (/x) of the destination device’s IP
address.
ip-address Enter the IP address in dotted decimal format of the forwarding router.
interface
Enter the following keywords and slot/port or number information:
IPv4 Routing
235