Users Guide

14
IPv4 Routing
The aggregator supports both IPv4 and IPv6 routing and these are used only for the management purpose.
This chapter describes the IPv4 related commands. They are:
• clear tcp statistics
• debug ip dhcp
• debug ip icmp
• ip route
• management route
• show arp
• show ip management-route
• show ip multicast-cam stack-unit
• show ip interface
• show ip route
• show tcp statistics
clear tcp statistics
Clear the TCP counters.
Syntax
clear tcp statistics
Command Modes EXEC Privilege
Supported Modes All Modes
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
9.4(0.0) Supported on the FN I/O Aggregator.
8.3.17.0 Supported on the M I/O Aggregator.
debug ip dhcp
Enable debug information for DHCP relay transactions and display the information on the console.
Syntax
debug ip dhcp
Parameters
debug ip dhcp To disable debug, use the no debug ip dhcp command.
IPv4 Routing
233