Users Guide

To return to the default setting, use the no speed {1000 | 10000 |auto} command.
Parameters
1000 Enter the keyword 1000 to set the interface’s speed to 1000 Mb/s.
10000 Enter the keyword 10000 to set the interface’s speed to 10000 Mb/s. Auto-
negotiation is enabled. For more information, refer to name
auto Enter the keyword auto to set the interface to auto-negotiate its speed. Auto-
negotiation is enabled. For more information, refer to name.
Defaults auto
Command Modes INTERFACE
Supported Modes All Modes
Command History
Version Description
9.4(0.0) Supported on the FN I/O Aggregator.
8.3.17.0 Supported on the M I/O Aggregator.
Usage Information
This command is found on the 1000/10000 Base-T Ethernet interfaces.
When you enable auto, the system performs and automatic discovery to determine the optics installed and
congure the appropriate speed.
When you congure a speed for the 1000/10000 interface, conrm the negotiation auto command
setting. Both sides of the link must should have auto-negotiation either enabled or disabled. For speed
settings of 1000 or auto, the software sets the link to auto-negotiation and you cannot change that setting.
Related Commands
negotiation auto — enables or disables auto-negotiation on an interface.
stack-unit portmode
Split a single 40G port into 4-10G ports on the MXL switch.
Syntax
stack-unit stack-unit port number portmode quad
Parameters
stack-unit Enter the stack member unit identier of the stack member to reset. The range is 0
to 5.
NOTE: The MXL switch commands accept Unit ID numbers from 0 to 5,
though the MXL switch supports stacking up to three units only with the
Dell Networking OS version 8.3.7.1.
number Enter the port number of the 40G port to be split. Enter one of the following port
numbers for the MXL switch: 48, 52, 56, or 60.
Defaults Disabled.
Command Modes CONFIGURATION
228
Interfaces