Users Guide

source (port monitoring for 40-Gigabit Ethernet)
Congure a port monitor source and destination. Starting with Dell Networking OS Release 9.3(0.0), you can also congure a 40-
Gigabit Ethernet interface as the destination interface or port to which the monitored trac is sent .
Syntax
source interface destination interface direction {rx | tx | both}
To disable a monitor source, use the no source interface destination interface
direction {rx | tx | both} command.
Parameters
interface Enter the one of the following keywords and slot/port information:
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port information.
• For a 40-Gigabit Ethernet interface, enter the keyword fortyGigE then the
slot/port information.
destination Enter the keyword destination to indicate the interface destination.
direction {rx | tx |
both}
Enter the keyword direction then one of the packet directional indicators.
• rx: to monitor receiving packets only.
• tx: to monitor transmitting packets only.
• both: to monitor both transmitting and receiving packets.
Defaults none
Command Modes MONITOR SESSION (conf-mon-sess-session-ID)
Supported Modes All Modes
Command History
Version Description
9.3(0.0) Added support for the fortyGigE keyword on M I/O Aggregator.
8.3.17.0 Supported on M I/O Aggregator.
Example
Dell(conf-mon-sess-1)# source tengigabitethernet 0/1 destination
tengigabitethernet 0/45 direction rx
Dell(conf-mon-sess-1)#
Dell(conf-mon-sess-1)#do show monitor session
SessID Source Destination Dir Mode Source IP
Dest IP
------ ------ ----------- --- ---- ---------
--------
1 Te 0/1 Te 0/45 rx Port N/A
N/A
Dell(conf-mon-sess-1)#
speed (for 1000/10000 interfaces)
Set the speed for 1000/10000 Base-T Ethernet interfaces. Both sides of a link must be set to the same speed (1000/10000) or to
auto or the link may not come up.
Syntax
speed {1000 | 10000 | auto}
Interfaces
227