Users Guide

Example (Using a
VLAN Name)
Dellconf)#interface vlan 222
Dell(conf-if-vl-222)#name test
Dell(conf-if-vl-222)#do show vlan name test
Codes: * - Default VLAN, G - GVRP VLANs
Q: U - Untagged, T - Tagged
x - Dot1x untagged, X - Dot1x tagged
G - GVRP tagged, M - Vlan-stack
NUM Status Description Q Ports
222 Inactive U TenGig 1/22
Dell(conf-if-vl-222)#
Dell#
Related Commands
interface vlan — Congures a VLAN.
shutdown
Disable an interface.
Syntax
shutdown
To activate an interface, use the no shutdown command.
Defaults The interface is disabled.
Command Modes INTERFACE
Supported Modes All Modes
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
9.4(0.0) Supported on the FN I/O Aggregator.
8.3.17.0 Supported on the M I/O Aggregator.
Usage Information
The shutdown command marks a physical interface as unavailable for trac. To discover if an interface is
disabled, use the show ip interface command. Disabled interfaces are listed as down.
Disabling a VLAN or a port channel causes dierent behavior. When a VLAN is disabled, the Layer 3
functions within that VLAN are disabled. Layer 2 trac continues to ow. Entering the shutdown
command on a port channel disables all trac on the port channel and the individual interfaces within the
port channel. To enable a port channel, you must enter no shutdown on the port channel interface and at
least one interface within that port channel.
The shutdown and description commands are the only commands that you can congure on an
interface that is a member of a port channel.
Related Commands
vlan tagged —Test the condition of copper cables on 100/1000/10G Base-T modules.
interface vlan — Creates a VLAN.
show ip interface — Displays the interface routing status. Add the keyword brief to display a table of
interfaces and their status.
226
Interfaces