Users Guide

Te 0/3 Down Auto Auto --
Te 0/4 Down Auto Auto --
Te 0/5 Down Auto Auto --
Te 0/6 Down Auto Auto --
Te 0/7 Down Auto Auto --
Te 0/8 Up 1 0000 Mbit Full --
Te 0/9 Down Auto Auto --
Te 0/10 Down Auto Auto --
Te 0/11 Down Auto Auto --
Te 0/12 Down Auto Auto --
Te 0/13 Down Auto Auto --
Te 0/14 Down Auto Auto --
Te 0/15 Down Auto Auto --
Te 0/16 Up 10000 Mbit Full --
show interfaces switchport
Display only virtual and physical interfaces in Layer 2 mode. This command displays the Layer 2 mode interfaces’ IEEE 802.1Q tag
status and VLAN membership.
Syntax
show interfaces switchport [interface | stack-unit unit-id ]
Parameters
interface (OPTIONAL) Enter one of the following keywords and slot/port or number
information:
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet followed by the slot/port information.
• Enter the keyword backup to view the backup interface for this interface.
NOTE: This command also enables you to view information corresponding
to a range of ports.
•
For physical interfaces, you can specify multiple ports as slot/port-
range. For example, if you want to display information corresponding to all
ports between 1 and 4, specify the port range as show interfaces
interface-type 1/1 - 4.
• For port–channel interfaces, you can specify multiple ports as port-
range. For example, if you want to display information corresponding to all
ports between 1 and 4, specify the port range as show interfaces
port—channel 1 - 4.
stack-unit unit-id (OPTIONAL) Enter the keywords stack-unit followed by the stack member
number. The range is from 0 to 5.
Command Modes
• EXEC
• EXEC Privilege
Supported Modes All Modes
Command History
Version Description
9.9(0.0) Introduced on the FN IOM and added support to display the interface
congurations corresponding to a range of ports.
9.4(0.0) Supported on the FN I/O Aggregator.
222
Interfaces