Users Guide

0 CRC, 0 overrun, 0 discarded
Output Statistics:
0 packets, 0 bytes, 0 underruns
0 64-byte pkts, 0 over 64-byte pkts, 0 over 127-byte pkts
0 over 255-byte pkts, 0 over 511-byte pkts, 0 over 1023-byte pkts
0 Multicasts, 0 Broadcasts, 0 Unicasts
0 throttles, 0 discarded, 0 collisions
Rate info (interval 299 seconds):
Input 00.00 Mbits/sec, 0 packets/sec, 0.00% of line-rate
Output 00.00 Mbits/sec, 0 packets/sec, 0.00% of line-rate
Time since last interface status change: 5d5h23m
!-------------output truncated ----------------!
Related Commands
show diag — Displays data plane and management plane input/output statistics.
show interfaces status
Displays a summary of interface information or specify a stack unit and interface to display status information for that specic
interface only.
Syntax
show interfaces [interface | stack-unit unit-number] status
Parameters
interface (OPTIONAL) Enter one of the following keywords and slot/port or number
information:
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet followed by the slot/port information.
unit-number Enter the stack unit’s ID number. The range is from 0 to 5.
NOTE: This command also enables you to view information corresponding to a range of ports.
• You can specify multiple ports as slot/port-range. For example, if you want to display
information corresponding to all ports between 1 and 4, specify the port range as
show
interfaces interface-type 1/1 - 4.
Defaults none
Command Modes
• EXEC
• EXEC Privilege
Supported Modes All Modes
Command History
Version Description
9.9(0.0) Introduced on the FN IOM and added support to display the interface
congurations corresponding to a range of ports.
9.4(0.0) Supported on the FN I/O Aggregator.
8.3.17.0 Supported on the M I/O Aggregator.
Example
Dell#show interface status
Port Description Status Speed Duplex Vlan
Te 0/1 Down Auto Auto --
Te 0/2 Down Auto Auto --
Interfaces
221