Users Guide

Command Modes INTERFACE CONFIGURATION
Command History
Version 9.7(0.0) Introduced on the M I/O Aggregator.
Usage Information
By default, the M I/O Aggregator processes RFI errors transmitted by remote peers and brings down the
interface when an RFI error is detected.
Example
Dell(conf-if-te-1/3)#remote-fault-signaling rx ?
on Enable
off Disable
show cong (INTERFACE mode)
Displays the interface conguration.
Syntax
show config
Command Modes INTERFACE
Supported Modes All Modes
Command History
Version Description
9.4(0.0) Supported on the FN I/O Aggregator.
8.3.17.0 Supported on the M I/O Aggregator.
Example
Dell(conf-if)#show conf
!
interface TenGigabitEthernet 1/7
no ip address
switchport
no shutdown
Dell(conf-if)#
show
cong (from INTERFACE RANGE mode)
Display the bulk congured interfaces (group).
Syntax
show config
Command Modes CONFIGURATION INTERFACE (conf-if-range)
Supported Modes All Modes
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
9.4(0.0) Supported on the FN I/O Aggregator.
8.3.17.0 Supported on the M I/O Aggregator.
210
Interfaces