Users Guide

Supported Modes All Modes
Command History
Version Description
9.9(0.0) Introduced on the FN IOM and added support to clear the interface congurations
corresponding to a range of ports.
9.4(0.0) Supported on the FN I/O Aggregator.
8.3.17.0 Supported on the M I/O Aggregator.
Example
Dell#clear counters
Clear counters on all interfaces [confirm]
clear mac-address-table dynamic
Clear the MAC address table of all MAC addresses learned dynamically.
Syntax
clear mac-address-table dynamic {interface tengigabitethernet slot/port-id}
Parameters
interface Enter the keyword interface range and one of the interfaces — slot/port,
port-channel or VLAN number. Select the range of interfaces for bulk
conguration. You can enter up to six comma separated ranges-spaces are not
required between the commas. Comma-separated ranges can include VLANs, port-
channels and physical interfaces.
Slot/Port information must contain a space before and after the dash. For
example, interface range tengigabitethernet 0/1 - 5 is valid; interface range
tengigabitethernet 0/1-5 is not valid.
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet followed by the slot/port information.
Command Modes EXEC Privilege
Supported Modes All Modes
Command History
Version Description
9.4(0.0) Supported on the FN I/O Aggregator.
8.3.17.0 Supported on the M I/O Aggregator.
default vlan-id
Set the default VLAN ID.
Syntax
default vlan-id <vlan-id>
To reset the default VLAN ID, use the no default vlan-id command.
Defaults none
Interfaces
193