Users Guide
Version Description
9.2(0.0) Introduced on the M I/O Aggregator.
Usage Information Dell Networking OS provides the capability of statically conguring the interface to which a multicast router
is attached. To congure a static connection to the multicast router, enter the ip igmp snooping
mrouter interface command in the VLAN context. The interface to the router must be a part of the
VLAN where you are entering the command.
ip igmp snooping querier
Enable IGMP querier processing for the VLAN interface.
Syntax
ip igmp snooping querier
To disable IGMP querier processing for the VLAN interface, use the no ip igmp snooping querier
command.
Defaults Not congured.
Command Modes INTERFACE VLAN — (conf-if-vl-n)
Supported Modes Programmable-Mux (PMUX)
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
9.4(0.0) Supported on the FN I/O Aggregator.
9.2(0.0) Introduced on the M I/O Aggregator.
Usage Information This command enables the IGMP switch to send General Queries periodically. This behavior is useful when
there is no multicast router present in the VLAN because the multicast trac is not routed. Assign an IP
address to the VLAN interface for the switch to act as a querier for this VLAN.
ip igmp version
Manually set the version of the router to IGMPv2 or IGMPv3.
Syntax
ip igmp version {2 | 3}
Parameters
2 Enter the number 2 to set the IGMP version number to IGMPv2.
3 Enter the number 3 to set the IGMP version number to IGMPv3.
Defaults 2 (that is, IGMPv2)
Command Modes INTERFACE
Supported Modes Programmable-Mux (PMUX)
Internet Group Management Protocol (IGMP)
185