Users Guide

Version
9.7(0.0) Introduced on the M I/O Aggregator.
Example
Dell(conf)#fc zoneset test1
Dell(conf-fc-zoneset-test1)#member ?
WORD Zone Name
Dell(conf-fc-zoneset-test1)#member
Related Commands
show fc zoneset — displays the congured and active zoneset.
show fcoe-map — displays the fabric parameters.
fcoe-map
Create an FCoE map which contains the parameters used to congure the links between server CNAs and a SAN fabric. Apply the
FCoE map on a server-facing Ethernet port.
Syntax
fcoe-map map-name
Parameters
map-name Maximum: 32 alphanumeric characters.
Defaults None
Command Modes CONFIGURATION
INTERFACE
Supported Modes All Modes
Command History
Version Description
9.9(0.0) Supported on the FN I/O Aggregator.
9.3(0.0) Introduced on the M I/O Aggregator.
Usage Information
An FCoE map is a template to map FCoE and FC parameters in a converged fabric. An FCoE map virtualizes
upstream FC ports on the switch NPIV proxy gateway to appear to downstream server CNA ports as FCoE
forwarder (FCF) ports on an FCoE network. When applied to FC and Ethernet ports on an NPIV proxy
gateway, an FCoE map allows the switch to operate as an FCoE-FC bridge between an FC SAN and an
FCoE network. It provides necessary parameters to FCoE-enabled servers and switches to log in to a SAN
fabric.
On the switch NPIV proxy gateway, an FCoE map is applied on fabric-facing FC ports and server-facing
Ethernet ports. Use the fcoe-map command to apply an FCoE map on an Ethernet port. Use the fabric
command to apply an FCoE map on an FC port.
An FCoE map consists of the following parameters: the dedicated FCoE VLAN for storage trac, the
destination SAN fabric (FC-MAP value), FCF priority, and the FIP keepalive (FKA) advertisement timeout.
To remove an FCoE map from an Ethernet interface, enter the no fcoe-map map-name command in
Interface conguration mode.
FC FLEXIO FPORT
157