Users Guide

active-zoneset
Activate the zoneset.
Syntax
active-zoneset zoneset_name
To change to the default zone behavior, use the no active-zoneset zoneset_name command.
Parameters
zoneset_name Enter the zoneset name.
Command Modes FC FABRIC CONFIGURATION
Supported Modes All Modes
Command History
Version Description
9.9(0.0) Supported on the FN I/O Aggregator.
9.7(0.0) Introduced on the M I/O Aggregator.
Example
Dell(conf)# fcoe-map default_full_fabric
Dell(conf-fcoe-default_full_fabric)# fc-fabric
Dell(conf-fmap-default_full_fabric-fcfabric)# active-zoneset zs1
Related Commands
show fc zoneset — displays the congured and active zoneset.
fabric
Apply an FCoE map on a fabric-facing Fibre Channel (FC) port.
Syntax
fabric map-name
Parameters
map-name Maximum: 32 alphanumeric characters.
Defaults None
Command Modes INTERFACE FIBRE_CHANNEL
Supported Modes All Modes
Command History
Version Description
9.9(0.0) Supported on the FN I/O Aggregator.
9.7(0.0) Introduced on the M I/O Aggregator.
Usage Information
An FCoE map is a template used to map FCoE and FC parameters in a converged fabric. An FCoE map
virtualizes the upstream FC ports on the switch NPIV proxy gateway to appear to downstream server CNA
ports as FCoE forwarder (FCF) ports on an FCoE network. When applied to FC and Ethernet ports on an
NPIV proxy gateway, an FCoE map allows the switch to operate as an FCoE-FC bridge between an FC SAN
and an FCoE network. It provides necessary parameters to FCoE-enabled servers and switches to log in to a
SAN fabric. Use the fcoe-map command to create an FCoE map.
154
FC FLEXIO FPORT