Users Guide

Fabric Name si
Fabric Id 1004
Vlan Id 1004
Vlan priority 3
FC-MAP 0efc04
FKA-ADV-Period 8
Fcf Priority 128
Config-State ACTIVE
Oper-State DOWN
Members
Related Commands
fcoe-map — creates an FCoE map which contains the parameters used in the communication between
servers and a SAN fabric.
show npiv devices
Display the FCoE and FC devices currently logged into an M I/O Aggregator with the FC Flex IO module NPIV proxy gateway.
M I/O Aggregator with the FC Flex IO module
Syntax
show npiv devices [brief]
Parameters
brief Displays an overview of current server CNA-fabric connections over an M I/O Aggregator with the FC
Flex IO module NPIV proxy gateway.
Command Modes
• EXEC
• EXEC Privilege
Supported Modes All Modes
Command History
Version Description
9.3(0.0) Introduced on the M I/O Aggregator and MXL 10/40GbE Switch with the FC Flex IO module.
Usage Information
Use the show npiv devices command to display information on the server CNA, server-facing Ethernet and fabric-facing FC
ports, and the SAN fabric in each server-fabric connection over an M I/O Aggregator with the FC Flex IO module that operates as
an NPIV proxy gateway.
The following table describes the show npiv devices brief output shown in the example below.
Field Description
ENode-Intf M I/O Aggregator with the FC Flex IO module Ethernet interface (slot/port) to which a server CNA is
connected.
ENode-WWPN Worldwide port name (WWPN) of a server CNA port.
FCoE-Vlan VLAN ID of the dedicated VLAN used to transmit FCoE trac to and from the fabric.
Fabric-Intf Fabric-facing Fibre Channel port (slot/port) on which FC trac is transmitted to the specied fabric.
150
FC Flex IO Modules