Users Guide

Version Description
9.2(0.0) Introduced on the M I/O Aggregator.
8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
Usage Information Specify a stack-unit number on the Master switch in a stack.
Example
Dell#show dcb
stack-unit 0 port-set 0
DCB Status : Enabled
PFC Queue Count : 2
Total Buffer[lossy + lossless] (in KB) : 3822
PFC Total Buffer (in KB) : 1912
PFC Shared Buffer (in KB) : 832
PFC Available Buffer (in KB) : 1080
show interface dcbx detail
Displays the DCBX conguration on an interface.
Syntax
show interface port-type slot/port dcbx detail
Parameters
port-type Enter the port type.
slot/port Enter the slot/port number.
NOTE: This command also enables you to view information corresponding to a range of ports.
• You can specify multiple ports as slot/port-range. For example, if you want to display
information corresponding to all ports between 1 and 4, specify the port range as show
interfaces
interface-type 1/1 - 4.
Command Modes CONFIGURATION
Supported Modes All Modes
Command History
Version Description
9.9(0.0) Introduced on the FN IOM and added support to display the interface
congurations corresponding to a range of ports.
9.4(0.0) Supported on the FN I/O Aggregator.
9.2(0.0) Introduced on the M I/O Aggregator.
8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
Usage Information
To clear DCBX frame counters, use the clear dcbx counters interface stack-unit/port
command.
The following describes the show interface dcbx detail command shown in the following example.
Field Description
Interface Interface type with chassis slot and port number.
Data Center Bridging (DCB)
121