Reference Guide

u-Boot | 77

u-Boot

Overview

All commands in this chapter are in u-Boot mode. These commands are supported on the Dell Force10

Aggregator only.

To access this mode, hit any key when the following line appears on the console during a system boot:

Hit any key to stop autoboot:

You enter u-Boot immediately, as indicated by the BOOT_USER# prompt.

Commands

• boot change

• boot selection

• boot show net config retries

• boot write net config retries

• boot zero

• default gateway

• enable

• help

• ignore enable password

• ignore startup-config

• interface management ethernet ip address

• no default gateway

• no interface management ethernet ip address

• reload

• show boot blc

• show boot selection

• show bootflash

• show bootvar

• show default gateway

• show interface management ethernet

Note: Only the most frequently used commands available in uBoot mode are described in

this chapter.

In uBoot mode, you cannot use the Tab key for command completion.