Reference Guide

222 | Stacking Commands
www.dell.com | support.dell.com
Example
Figure 21-4. show system stack-ports topology Command Example
Related
Commands
show system stack-unit iom-mode
Displays the current iom-mode (stack/standalone) and the mode configured after next reboot.
Syntax
show system stack-unit <unit-number> iom-mode[configured]
Command Modes
EXEC Privilege
Command
History
show system stack-unit fanout
Displays the current 40GbE ports configured in fanout mode.
Syntax
show system stack-unit <unit-number> fanout [configured]
Command Modes
EXEC Privilege
Command
History
Table 21-1. show system stack-ports Command Description
Field Description
Topology Lists the topology of stack ports connected: Ring, Daisy chain, or Standalone
Interface The unit/port ID of the connected stack port on this unit
Link Speed Link Speed of the stack port in Gb/s
Admin
Status
The only currently listed status is Up.
Connection The stack port ID to which this unit’s stack port is connected
FTOS#show system stack-ports topology
Topology: Daisy chain
Interface Connection Trunk
Group
-----------------------------
0/33
0/37 1/37
1/33
1/37 0/37
FTOS#
power-cycle stack-unit Resets the designated stack member.
show diag Displays the data plane or management plane input and output statistics of the
designated component of the designated stack member.
show system Displays the current status of all stack members or a specific member.
Version 8.3.17.0 Supported on M I/O Aggregator
Version 8.3.17.0 Supported on M I/O Aggregator