Reference Guide

Interfaces | 149
Parameters
Defaults
none
Command Modes
EXEC
EXEC Privilege
Command
History
Example
Figure 11-26. show interfaces status Command Example
show interfaces switchport
Displays only virtual and physical interfaces in Layer 2 mode. This command displays the Layer 2
mode interfaces’ IEEE 802.1Q tag status and VLAN membership.
Syntax
show interfaces switchport [interface | stack-unit unit-id ]
Parameters
Command Modes
EXEC
EXEC Privilege
Command
History
interface
(OPTIONAL) Enter one of the following keywords and slot/port or number
information:
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet followed by the slot/port information.
Version 8.3.17.0 Supported on M I/O Aggregator
FTOS#show interface status
Port Description Status Speed Duplex Vlan
Te 0/1 Down Auto Auto --
Te 0/2 Down Auto Auto --
Te 0/3 Down Auto Auto --
Te 0/4 Down Auto Auto --
Te 0/5 Down Auto Auto --
Te 0/6 Down Auto Auto --
Te 0/7 Down Auto Auto --
Te 0/8 Up 10000 Mbit Full --
Te 0/9 Down Auto Auto --
Te 0/10 Down Auto Auto --
Te 0/11 Down Auto Auto --
Te 0/12 Down Auto Auto --
Te 0/13 Down Auto Auto --
Te 0/14 Down Auto Auto --
Te 0/15 Down Auto Auto --
Te 0/16 Up 10000 Mbit Full --
FTOS#
interface
Enter one of the following keywords and slot/port or number information:
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet
followed by the slot/port information.
• Enter the keyword
backup to view the backup interface for this interface.
stack-unit
unit-id
(OPTIONAL) Enter the keyword stack-unit followed by the stack member number.
Range: 0 to 5
Version 8.3.17.0 Supported on M I/O Aggregator