Reference Guide

140 | Interfaces
www.dell.com | support.dell.com
show config (from PROTOCOL LLDP mode)
Displays the LLDP configuration.
Syntax
show config
Command Modes
PROTOCOL LLDP
Example
Figure 11-18. show config Command Example for a Selected VLAN
show interfaces
Displays information on a specific physical interface or virtual interface.
Syntax
show interfaces interface
Parameters
Command Modes
EXEC
EXEC Privilege
Command
History
Usage
Information
Use this show interfaces command for details on a specific interface. Use the show interfaces
stack-unit
command for details on all interfaces on the designated stack unit.
On the M I/O Aggregator, the show interface output displays incorrect rate information details over time
for link monitoring when the rate-interval is configured for 5 seconds. Dell Force10 recommends using
higher rate-intervals such as 15 to 299 seconds to minimize the errors seen.
FTOS(conf-lldp)#show conf
!
protocol lldp
FTOS(conf-lldp)#
interface
Enter one of the following keywords and slot/port or number information:
• For the management interface on the stack-unit, enter the keyword
managementethernet followed by slot/port information. The slot and port range is 0.
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet followed by
the slot/port information.
• For a VLAN, enter the keyword vlan followed by a number from 1 to 4094.
• For a Port Channel interface, enter the keyword
port-channel followed by a number.
Range: 1-128
Version 8.3.17.0 Supported on M I/O Aggregator
Note: In the CLI output, the power value will be rounded to a 3-digit value. For receive/
transmit power that is less than 0.000, an snmp query will return the corresponding dbm value
even though the CLI displays as 0.000.