Reference Guide

128 | Interfaces
www.dell.com | support.dell.com
Parameters
Defaults
Without a specific interface specified, the command clears all interface counters.
Command Modes
EXEC Privilege
Command
History
Example
Figure 11-1. clear counters Command Example
clear mac-address-table dynamic
Clear the MAC address table of all MAC addresses learned dynamically.
Syntax
clear mac-address-table dynamic {interface tengigabitethernet slot/port-id}
Parameters
Command Modes
EXEC Privilege
Command
History
interface
(OPTIONAL) Enter any of the following keywords and slot/port or number to clear
counters from a specified interface:
• For the management interface on the stack-unit, enter the keyword
managementethernet followed by slot/port information. The slot and port
range is 0.
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet
followed by the slot/port information.
• For a Port Channel interface, enter the keyword
port-channel followed by a
number. Range: 1-128
Version 8.3.17.0 Supported on M I/O Aggregator
FTOS#clear counters
Clear counters on all interfaces [confirm]
interface Enter the keyword interface range and one of the interfaces — slot/port,
port-channel or VLAN number. Select the range of interfaces for bulk configuration.
You can enter up to six comma separated ranges—spaces are not required between the
commas. Comma-separated ranges can include VLANs, port-channels and physical
interfaces.
Slot/Port information must contain a space before and after the dash. For example,
interface range tengigabitethernet 0/1 - 5 is valid; interface range
tengigabitethernet 0/1-5
is not valid.
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet
followed by the slot/port information.
Version 8.3.17.0 Supported on M I/O Aggregator