Users Guide

Version Description
8.3.17.0 Supported on the M I/O Aggregator.
Usage Information When you enter the traceroute command without specifying an IP address (Extended Traceroute), you are
prompted for a target and source IP address, timeout in seconds (default is 5), a probe count (default is 3),
minimum TTL (default is 1), maximum TTL (default is 30), and port number (default is 33434). To keep the default
setting for those parameters, press the ENTER key.
Example (IPv4)
Dell#traceroute www.force10networks.com
Translating "www.force10networks.com"...domain server (10.11.0.1)
[OK]
Type Ctrl-C to abort.
---------------------------------------------------
Tracing the route to www.force10networks.com (10.11.84.18),
30 hops max, 40 byte packets
----------------------------------------------------
TTL Hostname Probe1 Probe2 Probe3
1 10.11.199.190 001.000 ms 001.000 ms 002.000 ms
2 gwegress-sjc-02.force10networks.com (10.11.30.126)
005.000 ms 001.000 ms 001.000 ms
3 fw-sjc-01.force10networks.com (10.11.127.254)
000.000 ms 000.000 ms 000.000 ms
4 www.force10networks.com (10.11.84.18)
000.000 ms 000.000 ms 000.000 ms
Dell#
Related Commands
ping — Tests the connectivity to a device.
undebug all
Disable all debug operations on the system.
Syntax
undebug all
Defaults none
Command Modes
• EXEC Privilege
Supported Modes All Modes
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
9.4(0.0) Supported on the FN I/O Aggregator.
8.3.17.0 Supported on the M I/O Aggregator.
write
Copy the current conguration to either the startup-conguration le or the terminal.
Syntax
write {memory | terminal}
Parameters
memory
Enter the keyword memory to copy the current running conguration to the startup
conguration le. This command is similar to the copy running-config startup-
config
command.
Control and Monitoring 85