Users Guide

NOTE: The full transfer includes the core les as well in the information sent. The core transfer does not
send core les that are older than 30 days.
SupportAssist Commands
Dell EMC Networking OS supports the following SupportAssist mode commands.
activity
Move to the SupportAssist Activity mode for an activity. Allow the user to congure customized details for a specic activity.
Syntax
activity {activity-name}
To remove all customized detail for a specic activity, use the no activity {activity-name} command.
Parameters
activity-name
Enter one of the following keywords:
• Enter the keyword full-transfer to enable or disable full transfer. You can create
a custom le to transfer the outputs from a set of show commands. By default, the
full transfer runs once in every 30 days.
•
Enter the keyword core-transfer to enable or disable core transfer.
• Enter the keyword event-transfer to enable or disable event transfer. You can
create a custom le to monitor a set of events.
Command Modes SUPPORTASSIST
Command History
This guide is platform-specic. For command information about other platforms, see the relevant Dell EMC
Networking OS Command Line Reference Guide.
Version Description
9.11(0.0)
Introduced on the M I/O Aggregator and FN IOM.
Introduced the core-transfer and event-transfer parameters.
9.10(0.1) Introduced on the S6010-ON and S4048T-ON.
9.10(0.0) Introduced on the S3148.
9.10(0.0) Introduced on the C9010, Z9100–ON, S6100–ON, and S3100 series.
9.9(0.0) Introduced on the S4810, S4820T, S3048–ON, S4048–ON, S5000, S6000, S6000–ON,
Z9500, MXL.
Usage Information
By default, each activity follows a set of default actions using a default schedule. Using this command, you can
customize the set of actions and disable a certain activity.
386 SupportAssist