Users Guide

NOTE: You can use this attribute to inform the SNMP engine about the vrf
instance to be used to reach the corresponding remote host to send Trap or
Inform message. If no VRF is specied, then the default VRF is used.
traps (OPTIONAL) Enter the keyword traps to send trap notications to the specied host.
The default is traps.
informs (OPTIONAL) Enter the keyword informs to send inform notications to the specied
host. The default is traps.
version 1 | 2c | 3 (OPTIONAL) Enter the keyword version to specify the security model then the security
model version number 1, 2c, or 3:
• Version 1 is the least secure version.
• Version 3 is the most secure of the security modes.
• Version 2c allows transmission of informs and counter 64, which allows for integers
twice the width of what is normally allowed.
The default is version 1.
auth (OPTIONAL) Enter the keyword auth to specify authentication of a packet without
encryption.
noauth (OPTIONAL) Enter the keyword noauth to specify no authentication of a packet.
priv (OPTIONAL) Enter the keyword priv to specify both authentication and then scrambling
of the packet.
community-string Enter a text string (up to 20 characters long) as the name of the SNMP community.
NOTE: For version 1 and version 2c security models, this string represents the
name of the SNMP community. The string can be set using this command;
however, Dell Networking OS recommends setting the community string using
the snmp-server community command before executing this command. For
version 3 security model, this string is the USM user security name.
udp-port port-
number
(OPTIONAL) Enter the keywords udp-port followed by the port number of the remote
host to use. The range is from 0 to 65535. The default is 162.
notication-type (OPTIONAL) Enter one of the following keywords for the type of trap to be sent to the
host:
• bgp — Enable BGP state change traps.
• ecfm — Enable ECFM state change traps.
•
entity — Enable entity change traps.
• envmon — Enable SNMP environmental monitor traps.
• eoam — Enable EOAM state change traps
• ets — Enable ets traps
• fips — Enable FIP Snooping state change traps
• lacp — Enable LACP state change traps.
• isis — Enable ISIS adjacency change traps
• pfc — Enable pfc traps
• snmp — Enable SNMP trap
• stp — Enable 802.1d state change traps
• vlt — Enable VLT traps
Simple Network Management Protocol (SNMP) and Syslog 363