Users Guide

1 If only aggregate input QoS policy exists, input trac conditioning congurations (rate-police) apply. Any
marking congurations in aggregate input QoS policy are ignored.
2 If aggregate input QoS policy and per class input QoS policy coexist, aggregate input QoS policy preempts per
class input QoS policy on input trac conditioning (rate-police). In other words, if rate police conguration
exists in the aggregate QoS policy, the rate police congurations in per class QoS are ignored. Marking
congurations in per class input QoS policy still apply to each queue.
Related Commands
policy-map-output — creates an output policy map.
policy-map-output
Create an output policy map.
Syntax
policy-map-output policy-map-name
To remove a policy map, use the no policy-map-output policy-map-name command.
Parameters
policy-map-name Enter the name for the policy map in character format (32 characters maximum).
Defaults none
Command Modes CONFIGURATION
Supported Modes Programmable-Mux (PMUX)
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
9.4(0.0) Supported on the FN I/O Aggregator.
9.2(0.0) Introduced on the M I/O Aggregator.
8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
Usage Information To assign trac to dierent ows using QoS policy, use the Output Policy map. This command enables Policy-
Map-Output Conguration mode (conf-policy-map-out).
Related Commands
service-queue — assigns a class map and QoS policy to dierent queues.
policy-aggregate — allows an aggregate method of conguring per-port QoS using policy maps.
service-policy output — applies an output policy map to the selected interface.
qos-policy-output
Create a QoS output policy.
Syntax
qos-policy-output qos-policy-name
To remove an existing output QoS policy, use the no qos-policy-output qos-policy-name command.
Parameters
qos-policy-name Enter your output QoS policy name in character format (32 characters maximum).
Quality of Service (QoS) 311