Users Guide

Example
Dell#debug track all
04:35:04: %RPM0-P:RP2 %OTM-5-STATE: track 6 - Interface TenGigabitEthernet 1/2
line-protocol DOWN
04:35:04: %RPM0-P:RP2 %OTM-5-NOTIF: VRRP notification: resource ID 6 DOWN
delay
Congure the time delay used before communicating a change in the status of a tracked object to clients.
Syntax
delay {[up seconds] [down seconds]}
To return to the default setting, use the no delay command.
Parameters
seconds Enter the number of seconds the object tracker waits before sending a notication about
the change in the UP and/or DOWN state of a tracked object to clients. The range is 0 to
180. The default is 0 seconds.
Defaults 0 seconds
Command Modes OBJECT TRACKING (conf_track_object-id)
Command History
Version Description
9.7(0.0) Introduced on the M I/O Aggregator.
Usage Information
You can congure an UP and/or DOWN timer for each tracked object to set the time delay before a change in the
state of a tracked object is communicated to clients. The congured time delay starts when the state changes
from UP to DOWN or vice-versa.
If the state of an object changes back to its former UP/DOWN state before the timer expires, the timer is
cancelled and the client is not notied. For example, if the DOWN timer is running when an interface goes down
and comes back up, the DOWN timer is cancelled and the client is not notied of the event.
If the timer expires and an object’s state has changed, a notication is sent to the client. If no delay is congured, a
notication is sent immediately after a change in the state of a tracked object is detected. The time delay in
communicating a state change is specied in seconds.
description
Enter a description of a tracked object.
Syntax
description {text}
To remove the description, use the no description {text} command.
Parameters
text Enter a description to identify a tracked object (80 characters maximum).
Defaults none
Command Modes OBJECT TRACKING (conf_track_object-id)
Object Tracking 289