Users Guide

Field Description
• L2 — for Layer 2
Status Displays the status of the port channel.
• down — if the port channel is disabled (shutdown)
• up — if the port channel is enabled (no shutdown)
Uptime Displays the age of the port channel in hours:minutes:seconds.
Ports Lists the interfaces assigned to this port channel.
(untitled) Displays the status of the physical interfaces (up or down).
• In Layer 2 port channels, an * (asterisk) indicates which interface is the primary port
of the port channel. The primary port sends out interface PDU.
• In Layer 3 port channels, the primary port is not indicated.
Example
Dell#show int po bri
Codes: L - LACP Port-channel
O - OpenFlow Controller Port-channel
A - Auto Port-channel
I - Internally Lagged
LAG Mode Status Uptime Ports
L 128 L3 down 00:00:00
Dell#
To indicate the LACP fallback, Internally lagged is added to the list. When the LAG auto-congures itself,
the LAG status describes as ‘I’.
Related Commands
show lacp — displays the LACP matrix.
show interfaces stack-unit
Display information on all interfaces on a specic Aggregator stack member.
Syntax
show interfaces stack-unit unit-number
Parameters
unit-number Enter the stack member number (0 to 5).
Command Modes
• EXEC
• EXEC Privilege
Supported Modes All Modes
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
9.4(0.0) Supported on the FN I/O Aggregator.
8.3.17.0 Supported on the M I/O Aggregator.
Interfaces 223