Users Guide

The DCBX configuration on the FCF-facing port is detected by the server-facing port and the DCB PFC

configuration on both ports is synchronized. For more information about how to configure DCBX and

PFC on a port, refer to FIP Snooping

After FIP packets are exchanged between the ENode and the switch, a FIP snooping session is

established. ACLS are dynamically generated for FIP snooping on the FIP snooping bridge/switch.

Debugging FIP Snooping

To enable debug messages for FIP snooping events, enter the debug fip-snooping command..

Task Command Command Mode

Enable FIP snooping debugging on for all or a

specified event type, where:

all enables all debugging options.

acl enables debugging only for ACL-specific

events.

error enables debugging only for error

conditions.

ifm enables debugging only for IFM events.

info enables debugging only for information

events.

ipc enables debugging only for IPC events.

rx enables debugging only for incoming

packet traffic.

debug fip-snooping [all

| acl | error | ifm |

info | ipc | rx]

EXEC PRIVILEGE

To turn off debugging event messages, enter the no debug fip-snooping command.

FIP Snooping