Users Guide

Software show Commands
Use the show version and show system stack-unit 0 commands as a part of troubleshooting an
Aggregator’s software configuration in a standalone or stacking scenario.
Table 31. Software show Commands
Command Description
show version Display the current version of Dell Networking OS software
running on an Aggregator.
show system stack-unit 0 Display software configuration on an Aggregator in stacking
mode.
show version Command Example
Dell#show version
Dell Real Time Operating System Software
Dell Operating System Version: 1.0
Dell Force10 Application Software Version: E8-3-17-24
Copyright (c) 1999-2014 by Dell Inc. All Rights Reserved.
Build Time: Thu Jul 5 11:20:28 PDT 2012
Build Path: /sites/sjc/work/build/buildSpaces/build05/E8-3-17/SW/SRC/Cp_src/
Tacacs
st-sjc-m1000e-3-72 uptime is 17 hour(s), 1 minute(s)
System Type: I/O-Aggregator
Control Processor: MIPS RMI XLP with 2147483648 bytes of memory.
256M bytes of boot flash memory.
1 34-port GE/TE (XL)
56 Ten GigabitEthernet/IEEE 802.3 interface(s)
Dell#
show system stack-unit 0 Command Example
Dell#show system stack-unit 0 | no-more
-- Unit 0 --
Unit Type : Management Unit
Status : online
Next Boot : online
Required Type : I/O-Aggregator - 34-port GE/TE (XL)
Current Type : I/O-Aggregator - 34-port GE/TE (XL)
Master priority : 0
Hardware Rev :
Num Ports : 56
Up Time : 17 hr, 8 min
FTOS Version : 8-3-17-15
Jumbo Capable : yes
POE Capable : no
Boot Flash : A: 4.0.1.0 [booted] B: 4.0.1.0bt
Boot Selector : 4.0.0.0
Memory Size : 2147483648 bytes
Temperature : 64C
Voltage : ok
Switch Power : GOOD
326
Debugging and Diagnostics