Users Guide

PfcMode:ON
--------------------
PG:0 TSA:ETS BW:30 PFC:OFF
Priorities:0 1 2 5 6 7
PG:1 TSA:ETS BW:30 PFC:OFF
Priorities:4
PG:2 TSA:ETS BW:40 PFC:ON
Priorities:3
Default FCoE map
Dell(conf)#do show fcoe-map
Fabric Name SAN_FABRIC
Fabric Id 1002
Vlan Id 1002
Vlan priority 3
FC-MAP 0efc00
FKA-ADV-Period 8
Fcf Priority 128
Config-State ACTIVE
Oper-State UP
Members
Fc 0/9
Te 0/4
DCB_MAP_PFC_OFF
Dell(conf)#do show qos dcb-map DCB_MAP_PFC_OFF
-----------------------
State :In-Progress
PfcMode:OFF
--------------------
Dell(conf)#
Enabling Fibre Channel Capability on the Switch
Enable the Fibre Channel capability on an Aggregator that you want to configure as an NPG for the Fibre
Channel protocol. When you enable Fibre Channel capability, FCoE transit with FIP snooping is
automatically enabled on all VLANs on the switch, using the default FCoE transit settings.
Task Command Command Mode
Enable the Fibre Channel capability on an
Aggregator for the Fibre Channel protocol.
feature fc
CONFIGURATION
Creating a DCB Map
Configure the priority-based flow control (PFC) and enhanced traffic selection (ETS) settings in a DCB
map before you apply them on downstream server-facing ports on an Aggregator.
NPIV Proxy Gateway
309