Users Guide

running-configuration command to verify that this TLV is advertised on all the configured interfaces
and the show lldp neighbors detail command to view the value of this TLV.
Enhanced Validation of Interface Ranges
You can avoid specifying spaces between the range of interfaces, separated by commas, that you
configure by using the interface range command. For example, if you enter a list of interface ranges,
such as interface range fo 2/0-1,te 10/0,gi 3/0,fa 0/0, this configuration is considered
valid. The comma-separated list is not required to be separated by spaces in between the ranges. You
can associate multicast MAC or hardware addresses to an interface range and VLANs by using the mac-
address-table static multicast-mac-address vlan vlan-id output-range interface
command.
Enhanced Control of Remote Fault Indication Processing
By default, the M I/O Aggregator module processes RFI errors transmitted by remote peers and brings
down the interface when an RFI error is detected.
You must enter the interface configuration mode before configuring Remote Fault Indication (RFI).
You can use the following CLI commands to enable or disable processing of received RFI events:
Dell(conf-if-te-1/3)#remote-fault-signaling rx ?
on Enable
off Disable
The default is "remote-fault-signaling rx on".
128
Interfaces