Users Guide

Name: TenGigabitEthernet 13/3
802.1QTagged: True
Vlan membership:
Vlan 2
--More--
Clearing Interface Counters
The counters in the show interfaces command are reset by the clear counters command. This
command does not clear the counters captured by any SNMP program.
To clear the counters, use the following command in EXEC Privilege mode:
Command Syntax Command Mode Purpose
clear counters [interface] EXEC Privilege Clear the counters used in the show interface commands
for all VRRP groups, VLANs, and physical interfaces or
selected ones.
Without an interface specified, the command clears all
interface counters.
• (OPTIONAL) Enter the following interface keywords
and slot/port or number information:
• For a Loopback interface, enter the keyword loopback
followed by a number from 0 to 16383.
• For a Port Channel interface, enter the keyword port-
channel followed by a number from 1 to 128.
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet followed by the slot/port
numbers.
• For a VLAN, enter the keyword vlan followed by a
number from 1 to 4094.
When you enter this command, you must confirm that you want Dell Networking OS to clear the
interface counters for the interface (refer to the below clearing interface example).
Clearing an Interface:
Dell#clear counters tengig 0/0
Clear counters on TenGigabitEthernet 0/0 [confirm]
Dell#
Enabling the Management Address TLV on All Interfaces
of an Aggregator
The management address TLV, which is an optional TLV of type 8, denotes the network address of the
management interface, and is supported by the Dell Networking OS. It is advertised on all the interfaces
on an I/O Aggregator in the Link Layer Discovery Protocol (LLDP) data units. You can use the show
Interfaces
127