Users Guide

Setting Auto-Negotiation Options:
Dell(conf)# int tengig 0/1
Dell(conf-if-te-0/1)#neg auto
Dell(conf-if-autoneg)# ?
end Exit from configuration mode
exit Exit from autoneg configuration mode
mode Specify autoneg mode
no Negate a command or set its defaults
show Show autoneg configuration information
Dell(conf-if-autoneg)#mode ?
forced-master Force port to master mode
forced-slave Force port to slave mode
Dell(conf-if-autoneg)#
Viewing Interface Information
Displaying Non-Default Configurations.
The show [ip | running-config] interfaces configured command allows you to display only
interfaces that have non-default configurations are displayed.
The below example illustrates the possible show commands that have the available configured
keyword.
Dell#show interfaces configured
Dell#show interfaces tengigabitEthernet 0 configured
Dell#show ip interface configured
Dell#show ip interface tengigabitEthernet 1 configured
Dell#show ip interface brief configured
Dell#show running-config interfaces configured
Dell#show running-config interface tengigabitEthernet 1 configured
In EXEC mode, show interfaces switchportcommand displays only interfaces in Layer 2 mode and
their relevant configuration information. The
show interfaces switchport command displays the
interface, whether the interface supports IEEE 802.1Q tagging or not, and the VLANs to which the
interface belongs.
show interfaces switchport Command Example:
Dell#show interfaces switchport
Name: TenGigabitEthernet 13/0
802.1QTagged: True
Vlan membership:
Vlan 2
Name: TenGigabitEthernet 13/1
802.1QTagged: True
Vlan membership:
Vlan 2
Name: TenGigabitEthernet 13/2
802.1QTagged: True
Vlan membership:
Vlan 2
126
Interfaces